​Quality custom & restoration sheet metal work & repair

A full set of Kent White upper and lower dies.

$6000.00

Phone calls always best.

206 234 8032

Danny Pascoe.

​It's on caster so it will roll around guessing it weighs over 200 lbs. I have a fork lift to help load.

​This is my 36 inch throat planishing hammer floor model 

Kent White receiver dryer and oiler with air adjuster and foot control.

The upper and lower arms made of 4x6x1/4 wall tubing and the back up wright is 4x8x 1/4 wall tubing and it was welded up on my jig table. It comes with 2 air motors from Kent white a # 2 and a #3. the motors mount in a Kent White quick change receiver and uses his lower tooling holder. Very stout and it works great.